The Parrot box simply plugs into,the two connectors, there is loads of wiring, and it looks a mess tbh, once it is all plugged in you can tape it all together to keep,it looking tidy, this takes a while, I hate messy wiring, but managed to sort it all out.
The pic shows the microphone and the display unit plugged in already, I will show the fitting of these next.
The Parrot box will stick to,the steel chassis on the right of the opening, it comes with adhesive pads.
Make sure you wires are clear of the handbrake mechanism, which obviously moves and could trap a carelessly fitted harness.
I fitted the microphone like this, other options are possible I guess, I drilled a 3 mm hole in the panel for the screw
Before fitting the display you click it into,the two casing halves, easily done
The next bit is quite tricky, offer the unit into,the corner of the roof, so,that you get a feel,for where you,want it to sit.
clean the roof area with a spirit, to get the adhesive pads to stick. Fit the little bracket into,the pod, and offer it up to,the roof again, the pads should stick the bracket to,the roof, and when you gently remove the pod, it will leave the bracket in position (hopefully. )